Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 8: Diffusion method (ISO 6145-8:2005)
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-EN ISO 6145-8:2008
Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 8: Diffusion method (ISO 6145-8:2005)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This part of ISO 6145 specifies a dynamic method using diffusion for the preparation of calibration gas mixtures containing component mole fractions ranging from 109 to 103. A relative expanded uncertainty of measurement, U, obtained by multiplying the relative combined standard uncertainty by a coverage factor k = 2, of not greater than 2 % can be achieved by using this method. By keeping the path between the diffusion source and place of use as short as possible, the method can be applied for the generation of low-concentration calibration gases of organic components that are liquid at room temperature, with boiling points ranging from about 40 °C to 160 °C. This part of ISO 6145 is applicable not only for the generation of calibration gas mixtures of a wide range of hydrocarbons at ambient and indoor air concentration levels, but also for the generation of low-concentration gas mixtures of water.
Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 8: Diffusion method (ISO 6145-8:2005)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions