Conditions for pressure classification of products for water and wastewater pipelines
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-EN 14801:2006
Conditions for pressure classification of products for water and wastewater pipelines
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This document applies to components (pipes, joints, fittings, ferrules and valves), which have pressure related
classification in European Standards covering products which are intended to be used for buried water supply
and waste water pressure pipelines outside buildings. It specifies combinations of loading conditions and
installation conditions to be used in the design method by reference to the relevant product standard for the
determination of the allowable pressures (PFA, PMA and PEA) as defined in EN 805.
This document does not apply as an installation guide.
NOTE 1 This document does not give the full range of installation and loading parameters for all components and does
not specify calculation and/or test methods for determination of the allowable pressures.
NOTE 2 This document does not relieve designers of their obligation under EN 805:2000, 8.4; e.g. to consider all
conditions not addressed in clause 5 (e. g. seismic loads).
NOTE 3 This document does not deal with marking of components.
Conditions for pressure classification of products for water and wastewater pipelines
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions