Standard Swedish standard · SS-EN ISO 13383-2:2016

Fine ceramics (advanced ceramics, advanced technical ceramics) - Microstructural characterization - Part 2: Determination of phase volume fraction by evaluation of micrographs (ISO 13383-2:2012)

Status: Valid

Buy this standard

Standard Swedish standard · SS-EN ISO 13383-2:2016

Fine ceramics (advanced ceramics, advanced technical ceramics) - Microstructural characterization - Part 2: Determination of phase volume fraction by evaluation of micrographs (ISO 13383-2:2012)
Subscribe on standards - Read more Dölj
Price: 875 SEK
standard ikon pdf

PDF

Price: 875 SEK
standard ikon

Paper

Price: 1 400 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Preview this standard
Scope
This part of ISO 13383 specifies a manual method of making measurements for the determination of the volume fraction of major phases in fine ceramics (advanced ceramics, advanced technical ceramics) using micrographs of polished and etched sections, overlaying a square grid of lines, and counting the number of intersections lying over each phase.NOTE 1 This method assumes that the true phase volume fractions are equivalent to area fractions on a randomly cut cross-section according to stereological principles.NOTE 2 Guidelines for polishing and etching of advanced technical ceramics can be found in Annexes A and B of ISO 13383-1:2012.The method applies to ceramics with one or more distinct secondary phases, such as found in Al2O3/ZrO2, Si/SiC, or Al2O3/SiCw.If the test material contains discrete pores, these are to be treated as a secondary phase for the purpose of this method, provided that there is no evidence of grain pluck-out during polishing being confused with genuine pores.NOTE 3 If the material contains more than about 20 % porosity, there is a strong risk that the microstructure will be damaged during the polishing process, and measurement of the volume fraction of pores may become misleading. Secondary phase volume fractions or porosity present at levels of less than 0,05 are subject to considerable error and potential scatter in results. A larger number of micrographs than the minimum of three is normally needed to improve the consistency and accuracy of the results.NOTE 4 Many ceramics contain small amounts of secondary glassy phases. In order to make a reasonable estimate of glassy phase content, the glass material between crystalline grains should be readily observable, and thus should be at least 0,5 µm in width. The method in this part of ISO 13383 is not considered appropriate for narrow glassy films around grains.

Subjects

Advanced ceramics (81.060.30)


Buy this standard

Standard Swedish standard · SS-EN ISO 13383-2:2016

Fine ceramics (advanced ceramics, advanced technical ceramics) - Microstructural characterization - Part 2: Determination of phase volume fraction by evaluation of micrographs (ISO 13383-2:2012)
Subscribe on standards - Read more Dölj
Price: 875 SEK
standard ikon pdf

PDF

Price: 875 SEK
standard ikon

Paper

Price: 1 400 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: Svenska institutet för standarder

International title:

Article no: STD-8020330

Edition: 1

Approved: 5/2/2016

No of pages: 28

Replaces: SS-EN 623-5:2009