Standard Swedish standard · SS-ISO 7919-5:2005

Mechanical vibration - Evaluation of machine vibration by measurements on rotating shafts - Part 5: Machine sets in hydraulic power generating and pumping plants (ISO 7919-5:2005, IDT)

Status: Withdrawn

· Replaced by: SS-ISO 20816-5:2018
Buy this standard

Standard Swedish standard · SS-ISO 7919-5:2005

Mechanical vibration - Evaluation of machine vibration by measurements on rotating shafts - Part 5: Machine sets in hydraulic power generating and pumping plants (ISO 7919-5:2005, IDT)
Subscribe on standards - Read more Dölj
Price: 1 013 SEK
standard ikon pdf

PDF

Price: 1 013 SEK
standard ikon

Paper

Price: 1 620,80 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Preview this standard
Scope
This part of ISO 7919 gives guidelines for applying evaluation criteria for shaft vibration measured at, or close to, the bearings of machines or machine sets in hydraulic power generating and pumping plants under normal operating conditions. These guidelines are presented in terms of both steady-state running vibration and any amplitude changes that can occur in these steady vibration values.
NOTE 1 The numerical values specified are not intended to serve as the only basis for vibration evaluation since, in general, the vibratory condition of a machine is assessed by consideration of both the shaft vibration and the associated structural vibration (see ISO 7919-1 and ISO 10816-1).
This part of ISO 7919 is applicable to machines or machine sets in hydraulic power generating and pumping plants where the hydraulic machines have speeds from 60 r/min to 1 800 r/min, shell- or shoe-type sleeve bearings, and main engine power of at least 1 MW. The position of the shaft line can be vertical, horizontal or at an arbitrary angle between these two directions.
Machine sets covered by this part of ISO 7919 include a combination of
-- hydraulic turbines and generators,
-- pumps and electrical machines operating as motors,
-- pump-turbines and motor-generators, and
-- hydraulic turbines, pumps and motor-generators (classic pump-storage machine sets),
including auxiliary equipment (e.g. starting turbines or exciters lying in the shaft line).
This part of ISO 7919 is also applicable to turbines or pumps connected to generators or electrical motors via gears and/or radially flexible couplings.
NOTE 2 Electrical machines with speeds between 1 000 r/min and 1 800 r/min are evaluated according to the criteria specified in ISO 7919-3.

Subjects

Vibrations, shock and vibration measurements (17.160) Generating sets (29.160.40)


Buy this standard

Standard Swedish standard · SS-ISO 7919-5:2005

Mechanical vibration - Evaluation of machine vibration by measurements on rotating shafts - Part 5: Machine sets in hydraulic power generating and pumping plants (ISO 7919-5:2005, IDT)
Subscribe on standards - Read more Dölj
Price: 1 013 SEK
standard ikon pdf

PDF

Price: 1 013 SEK
standard ikon

Paper

Price: 1 620,80 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: Svenska institutet för standarder

International title:

Article no: STD-39822

Edition: 2

Approved: 5/20/2005

No of pages: 19

Replaces: SS-ISO 7919-5

Replaced by: SS-ISO 20816-5:2018