Styrene-butadiene rubber (SBR) - Determination of the microstructure of solution-polymerized SBR - Part 2: FTIR with ATR method (ISO 21561-2:2016, IDT)
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-ISO 21561-2:2016
Styrene-butadiene rubber (SBR) - Determination of the microstructure of solution-polymerized SBR - Part 2: FTIR with ATR method (ISO 21561-2:2016, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This part of ISO 21561 specifies procedures for the quantitative determination of the microstructure of the butadiene and the content of styrene in solution-polymerized SBR (S-SBR) by Fourier Transform Infrared Spectrometry (FTIR) with Attenuated Total Reflection (ATR) method. The styrene content is expressed in mass % relative to the whole polymer. The vinyl, trans and cis contents are expressed in mol % relative to the butadiene content. This method is only applicable to raw rubbers.NOTE 1 Precision as shown in Annex A may not be obtained for S-SBRs containing polystyrene block or styrene content more than 45 mass %.NOTE 2 Only “vinyl”, “trans” and “cis”, are used in this part of ISO 21561. However, the expression of vinyl, trans and cis mean as follows in general:— vinyl: vinyl unit, vinyl bond, 1,2-unit, 1,2-bond, 1,2-vinyl-unit or 1,2-vinyl-bond;— trans: 1,4-trans unit, 1,4-trans bond, trans-1,4 unit or trans1,4 bond;— cis: 1,4-cis unit, 1,4-cis bond, cis-1,4 unit or cis-1,4 bond.
Styrene-butadiene rubber (SBR) - Determination of the microstructure of solution-polymerized SBR - Part 2: FTIR with ATR method (ISO 21561-2:2016, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions