Standard Svensk standard · SS-EN ISO 294-5:2017

Plast - Formsprutning av provkroppar av termoplast - Del 5: Beredning av standardprover för undersökning av anisotropi (ISO 294-5:2017)

Status: Gällande

Köp denna standard

Standard Svensk standard · SS-EN ISO 294-5:2017

Plast - Formsprutning av provkroppar av termoplast - Del 5: Beredning av standardprover för undersökning av anisotropi (ISO 294-5:2017)
Prenumerera på standarden - Läs mer Dölj
Pris: 735 SEK
standard ikon pdf

PDF

Pris: 735 SEK
standard ikon

Papper

Pris: 1 176 SEK
standard ikon pdf + standard ikon

PDF + papper

Fler alternativ Färre alternativ
Provläs denna standard
Omfattning
ISO 294-5:2017 specifies a mould (designated the type F ISO mould) for the injection moulding of plates with a preferred size of 80 mm × 120 mm and a minimum size of 80 mm × ≥90 mm and with a preferred thickness of 2 mm for single-point and multi-point data acquisition. It has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection. Whenever possible, a two cavity mould is intended to be used. For the design of plastic parts, this will provide upper and lower bounds for the tensile properties. Matching the plate thickness to a given part thickness is not a suitable criterion because of the effect of mould filling rate and part geometry on anisotropy.
Investigation of the anisotropy of materials is a special procedure intended to provide guidance in the design of mouldings for end-use applications and is not intended as a quality control tool.
In the injection moulding of thermoplastic materials, the flow of molten polymer can influence the orientation of fillers such as fibreglass or the orientation of polymer chains, resulting in anisotropic behaviour.
For the purposes of ISO 294-5:2017, the flow direction is defined as the direction from the gate to the far end of the mould cavity and the cross direction as the direction perpendicular to the flow direction.
The type F mould is not intended to replace the type D mould used to determine the moulding shrinkage of thermoplastics.

Ämnesområden

Termoplastmaterial (83.080.20)


Köp denna standard

Standard Svensk standard · SS-EN ISO 294-5:2017

Plast - Formsprutning av provkroppar av termoplast - Del 5: Beredning av standardprover för undersökning av anisotropi (ISO 294-5:2017)
Prenumerera på standarden - Läs mer Dölj
Pris: 735 SEK
standard ikon pdf

PDF

Pris: 735 SEK
standard ikon

Papper

Pris: 1 176 SEK
standard ikon pdf + standard ikon

PDF + papper

Fler alternativ Färre alternativ

Produktinformation

Språk: Engelska

Framtagen av: Plast, SIS/TK 156

Internationell titel: Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2017)

Artikelnummer: STD-80000304

Utgåva: 2

Fastställd: 2017-12-27

Antal sidor: 20

Ersätter: SS-EN ISO 294-5:2013